FJ ForceJump, Forces the miner to jump. This is necessary if the miner got stuck. (Holding this down also temporarily shuts down autojump, use this should the target finder get stuck.)
ACT Active, Set the miner On or Off (Turning the miner Off returns it to it's home-coordinates.)
Target Target Entity (from target finder target output)
HOMX Home Coordinate X
HOMY Home Coordinate Y
HOMZ Home Coordinate Z
Ore Current amout of Ore
OreM Maximum amout of Ore
Ranger Ranger, to get the range to the next asteroid/object. (Helps in detecting if a jump is required.)
Scan Scanner, detects amount of Ore remaining in current target.
CT Change Target, to switch to the next target. (Switches target then autojumps to it.)
Pulse Pulse Timing Circuit, Connect to a pulser with a TickTime of 1.
M Mode, 0 = Above, 1 = Beneath, 2/3 = X-Axis, 4/5 = Y-Axis, 6 = Centre (For miners designed to fit around an asteroid/object.)
O2* Oxygen in storage
En* Energy in storage
O2M* Maximum oxygen that can be stored
EnM* Maximum energy that can be stored

X X-Axis, Connect to the hoverdrive
Y Y-Axis, Connect to the hoverdrive
Z Z-Axis, Connect to the hoverdrive
TEL Teleport, Connect to the Jump and SetJumpTarget input of the hoverdrive
MLZ MiningLasers
Home Marker to tell you that the miner is parked at home.
NT Next Target, connect the "NextTarget" input of the targetfinder to this output.
OreRate* amount of raw ore gathered per second
EnRate* Energy generated (or used if negative) per second
O2Rate* oxygen generated (or used if negative) per second
Minutes* Minutes untill ore storages are full
Seconds* Seconds untill ore storages are full
O2Minutes* Minutes untill oxygen storages are full (or empty if negative)
O2Seconds* Seconds untill oxygen storages are full (or empty if negative)
EnMinutes* Minutes untill energy storages are full (or empty if negative)[
EnSeconds* Seconds untill energy storages are full (or empty if negative)[
O2P* Percentage of oxygen stores full
EnP* Percentage of energy stores full
OreP* Percentage of ore stores full